Dominator High Performance Expansion Pipe for Go-Ped GP460 (and GP420) engines. All solid mounting points. Hardware included.
Go-Ped Trail Ripper (GTR)
Go-Ped Trail Ripper Interceptor (GTRi)
Super Go-Quad 46
Trail Ripper Quad
IMPORTANT: Break in a new engine completely and properly before installing a High Performance Pipe. Once installed, the fuel air mixture will need to be richened to compensate for the additional air flow.
Posted by Joseph lowett on 16th Jun 2020
Pipe looks, sounds great and definitely added noticeable get up and go on my ped. My only gripe is that it did not install on my GTR46 without modification. I had to grind about 3/4 inch portion from between the mounting holes to get it to clear the chain/sprocket guard. I also had to trim a portion of my engine cover and shim it with 3 washers <not included> on each bolt to get the proper clearance from the pipe to the head. With these work arounds the pipe installed well. Additionally is was a pain to remove and reinstall the top rear motor mount bolt as it is blocked by the rear fender. I was able to bend the fender down to complete the install, but ideally raking off the gas tank and fender would likely make the install alot easier..... my main gripe is this was supposed to be a direct fit replacement but it wasn't since I had to mod it to fit. If it wasn't for that 5 starts all the way. Quality is good as is the major bump in performance.
All prices are in USD.